Location (Global Configuration) - Cisco Catalyst 3750 Metro Command Reference Manual

Chapter 2 Catalyst 3750 Metro Switch Cisco IOS Commands

location (global configuration)

Use the location global configuration command to configure location information for an endpoint. Use
the no form of this command to remove the location information.
Syntax Description
admin-tag
civic-location
elin-location
identifier id
string
Defaults This command has no default setting.
Command Modes Global configuration
Command History Release
12.2(40)SE
Usage Guidelines After entering the location civic-location identifier id global configuration command, you enter civic
location configuration mode. In this mode, you can enter the civic location and the postal location
information.
The civic-location identifier must not exceed 250 bytes.
Use the no lldp med-tlv-select location information interface configuration command to disable the
location TLV. The location TLV is enabled by default. For more information, see the "Configuring LLDP
and LLDP-MED" chapter of the software configuration guide for this release.
OL-9645-10
location {admin-tag string | civic-location identifier id | elin-location string identifier id}
no location {admin-tag string | civic-location identifier id | elin-location string identifier id}
Modification
This command was introduced.
Configure administrative tag or site information.
Configure civic location information.
Configure emergency location information (ELIN).
Specify the ID for the civic location or the elin location. The ID range
is 1 to 4095.
The identifier for the civic location in the LLDP-MED TLV is
Note
limited to 250 bytes or less. To avoid error messages about
available buffer space during switch configuration, be sure that
the total length of all civic-location information specified for
each civic-location identifier does not exceed 250 bytes.
Specify the site or location information in alphanumeric format.
Catalyst 3750 Metro Switch Command Reference
location (global configuration)
2-237