Adjusting Settings In The Quick Access Menu - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

6
6.5.2

Adjusting settings in the quick access menu

With the quick access menu, you can adjust the following settings:
Unit for linear values (Millimeters or Inch)
Unit for angular values (Radian, Decimal degrees or Deg-Min-Sec)
Type of coordinate system (Cartesian or Polar)
Magnification
Type of measuring point acquisition (Auto enter)
Timeout for automatic measuring point acquisition (Auto enter timeout in ms)
Setting the units of measure
Before you start measuring, you need to set the desired units of measure in the
Inspector's quick access menu.
Selecting the coordinate system
Depending on the measuring task, you can set the type of coordinate system in
the Inspector's quick access menu.
80
Tap the Quick access menu in the Inspector
Select the desired Unit for linear values
Select the desired Unit for angular values
Tap Close to close the quick access menu
The selected units are displayed in the Quick access menu
Tap the Quick access menu in the Inspector
Select the desired Type of coordinate system
Tap Close to close the quick access menu
The positions are displayed in the Position preview
according to the selected coordinate system
Basic operation | Using the Inspector
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016