Setting And Clearing Breakpoints - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

12
12.6.3

Setting and clearing breakpoints

When creating or editing a measuring program, you can stop the program run at
specified points. After being started, the measuring program stops at a breakpoint
and needs to be resumed or terminated. A breakpoint can be set at any program
step of the measuring program.
Breakpoints cannot be saved in the measuring program.
Setting a breakpoint
Removing a breakpoint
Removing all breakpoints
282
Tap the program step
The program step is highlighted
The breakpoint is displayed at the program step
Tap Breakpoint
A dot appears next to the name of the program step
The breakpoint is set
Tap the program step containing the breakpoint
The program step is highlighted
The breakpoint is displayed at the program step
Tap Breakpoint
The dot next to the name of the program step is removed
The breakpoint is cleared
Tap Remove breakpoints on the program control
All breakpoints are removed
Programming | Editing a measuring program
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016