Measuring A Feature - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

10
10.4.3

Measuring a feature

Sec. 10.4.1:
Preparing a measurement
This section describes the typical steps required for conducting a measurement.
The description provides an overview. Additional steps may be necessary
depending on the measuring machine or the respective measuring application.
A measurement consists of the following steps:
Selection of the appropriate geometry for the feature to be measured
Measuring point acquisition using the selected geometry
Further information:
210
Sec. 10.4.2:
Aligning the measured
object
"Capturing measuring points", page 193
The steps described in this section are the same for each measuring
process. The steps are illustrated using the "Circle" geometry as an
example.
Tap Measure in the main menu
Select Manual measuring
Select the Circle or Measure Magic geometry in the
geometry palette
If required, increase the workspace by hiding the main menu
or the Inspector
Move the measured object so that it is within the workspace
Activate or deactivate automatic measuring point acquisition
Further information:
acquisition", page 81
Select the Circle measuring tool
Position the measuring tool above the circle to be measured
Capture measuring points
Measurement | Conducting a measurement
Sec. 10.4.3:
Measuring a feature
"Setting automatic measuring point
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016