HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 343

Settings | Axes
Segmented linear error compensation (SLEC)
Parameter
Compensation
Table of supporting points
Create table of supporting points
Create table of supporting points
Parameter
Number of supporting points
Spacing of the supporting points
Start point
Create
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Explanation
Mechanical influences on the axes of the machine are compen-
sated
Settings:
ON: Compensation is active
OFF: Compensation is not active
Default value: OFF
The overview of the table of supporting points is opened for
manual editing
The menu for creating a new Table of supporting points is
opened
Explanation
Number of supporting points on the mechanical axis of the
measuring machine
For linear error compensation (LEC), use the
segmented linear error compensation (SLEC) function
to enter two supporting points that define the axis
as a single segment covering the entire measuring
range. In this way, linear compensation of the axis is
performed over the entire segment.
Setting range: 2 ... 200
Default value: 2
Spacing of the supporting points on the mechanical axis of the
measuring machine
The start point defines the point starting from which the
compensation is applied to the axis
Creates a new table of supporting points based on the entries
15
343