Setting The Measuring Application - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

Setup | Setup steps
8.3.3

Setting the measuring application

Sec. 8.3.1:
Basic settings
Configuring the measuring point acquisition
To measure the features, you can e.g. adjust the required minimum number of
measuring points or the settings for the measuring point filter.
Adjusting the General settings
Further information:
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Sec. 8.3.2:
Configuring sensors
Tap Settings in the main menu
Tap Features
Tap General settings
To set the measuring point acquisition to a fixed or free
number of measuring points, select the desired option in the
Number of measuring points drop-down list:
Fixed: Measuring point acquisition is concluded auto-
matically as soon as the specified minimum number of
measuring points for the geometry is reached
Free: The user can capture as many additional measuring
points as desired after reaching the required minimum
number of measuring points. When the minimum
number of points for the geometry has been reached, the
measuring point acquisition can be concluded manually
To display the distances between the measuring points as
absolute or direction-dependent values, select the desired
option in the Distances drop-down list:
Signed: The distance between the measuring points is
displayed depending on the measuring direction
Absolute: The distance between the measuring points is
displayed independently of the measuring direction
"General settings", page 330
Sec. 8.3.3:
Setting the measuring
application
8
151