Overview - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

7
7.1

Overview

During commissioning, the machine manufacturer's commissioning engineer
(OEM) configures the product for use in the specific measuring machine.
The settings can be reset to the factory defaults.
Further information:
Backing up the configuration
To back up the settings, you can back up the configuration data after
commissioning or setup. These configuration data can be reused for equivalent
products.
Before the backed-up configuration data can be restored to a product, the software
options that were active during the backup must be activated on the respective
product.
Further information:
104
Make sure that you have read and understood the "Basic Operation"
chapter before performing the activities described below.
Further information: "Basic operation", page 51
The following steps must be performed only by qualified personnel.
Further information: "Personnel qualification", page 19
"Resetting to the factory defaults", page 350
"Backing up and restoring the configuration", page 346
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Commissioning | Overview