HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 280

12
Adjusting the lighting
Adjusting a feature
280
Drag the program step for setting the lighting to the left into
the workspace
The lighting settings are displayed
Adjust the lighting
Further information:
Tap Finish in the program step
The lighting settings are applied
If changes are made to a measuring program, the measuring program
needs to be saved again.
Further information: "Saving a measuring program", page 275
Drag the program step of the feature to the left into the
workspace
The Overview and Tolerances tabs are displayed
On the Overview tab, adjust the settings of the feature
Further information:
On the Tolerances tab, adjust the tolerancing of the feature
Further information:
General tolerances are applied to all tolerances
of the features unless they are overwritten
manually or ISO 286 is applied.
Tap Close to close the dialog
The settings and tolerances are saved for the feature
If changes are made to a measuring program, the measuring program
needs to be saved again.
Further information: "Saving a measuring program", page 275
Programming | Editing a measuring program
"Adjusting the lighting", page 94
"Evaluating a feature", page 250
"Defining tolerances", page 252
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016