HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 181

Quick Start | Conducting a measurement
Short description
1 Display of general tolerance
2 List of tolerances, depending on feature
3 Status of the tolerance: active and within the tolerance or active and outside
the tolerance
On the Tolerances tab, you can define the geometrical tolerancing of a measured
or constructed feature. The tolerances are grouped.
Tolerances cannot be applied to reference features, such as zero point,
alignment and reference plane.
Depending on the feature, you can define the following tolerance types:
General tolerances, e.g. application of the ISO 2768 standard
Size tolerances, e.g. diameter, width, length and angle of reference axis
Form tolerances, e.g. roundness
Location tolerances, e.g. position, concentricity
Directional tolerances, e.g. angularity, parallelism, perpendicularity
Runout tolerances
The tolerances can be activated or deactivated.
Further information:
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
1
3
"Tolerancing the features", page 258
2
9
181