Overview; Assembly Of The Device - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

4
4.1

Overview

This chapter contains all the information necessary for mounting the product.
4.2

Assembly of the device

General mounting information
The receptacle for the mounting variants is provided on the rear panel. The
connection is compatible with VESA standard 100 mm x 100 mm.
The material for attachment of the mounting variants on the device is included in
delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Hex key, width A/F 2.5 (Duo-Pos stand)
Material for mounting on supporting surface
30
The following steps are only to be performed by qualified personnel.
Further information: "Personnel qualification", page 19
1 0 0
The product must be mounted on a stand or holder to ensure the
correct and intended operation of the product.
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Mounting | Overview