HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 207

Measurement | Conducting a measurement
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Select Buffer in the tool palette
Position the measuring tool above the reference edge
Expand the measuring tool so that the edge area enclosed in
the search range is as large as possible
Rotate the measuring tool so that the scan direction
corresponds to the desired scan direction
Select the edge detection mode at the bottom of the
workspace
Tap Enter in the Inspector
Multiple measuring points are captured along the edge
A new feature is displayed in the feature list of the Inspector
Distribute the measuring points along the entire
length of the edge, as far as possible. This
minimizes the angular error.
If the edge is interrupted or not fully displayed in the
workspace, reposition the measuring tool and capture more
measuring points
Tap Finish in the new feature
The alignment is displayed in the feature list of the Inspector
10
207