HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 200

10
Capturing measuring points with an active VED measuring tool
The active VED measuring tools vary in use and area of application. The measuring
point acquisition is the same for all active VED measuring tools.
Further information:
200
"Measuring tools", page 84
Tap Measure in the main menu
Select Manual measuring in the function palette
If more than one optical sensor is active, select VED sensor
in the sensor palette
The geometry palette and the VED measuring tools are
displayed
Tap Live image preview in the Inspector
The workspace shows the camera's live image
In the quick access menu, select the magnification that is set
on the measuring machine
Select Circle in the geometry palette
Select the appropriate measuring tool in the tool palette, e.g.
Circle
Position the measuring tool above the contour
Resize the two rings of the measuring tool so that the
contour is fully enclosed within the search range between
the inner and outer rings
If automatic measuring point acquisition is active, the
measuring points are captured automatically
Further information: "Setting automatic measuring point
acquisition", page 81
Select the edge detection mode at the bottom of the
workspace
A new feature is displayed in the feature list
If automatic measuring point acquisition is not active, tap
Enter in the Inspector
The measuring points are captured along the contour
If the number of measuring points is set to "Free" in the
feature settings, a new feature with a check mark is shown in
the feature list of the Inspector
Further information: "Adjusting the General settings",
page 151
The number of captured measuring points is shown next to
the symbol
Measurement | Capturing measuring points
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016