Connecting Printers - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

5
5.8

Connecting printers

Connecting a USB printer
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information:
Connect the USB printer to one of the USB Type A ports X31–X34. Make sure
the USB cable connector is fully inserted
Further information:
Pin layout of X31–X34
4 3 2
5 V DC
Connecting an Ethernet printer
Remove and save the dust protection caps
Route the cables depending on the mounting variant
Further information:
Connect the Ethernet printer to the Ethernet port X116 using a standard CAT.5
cable. The cable connector must firmly engage in the port
Further information:
Pin layout of X116
1 2 3 4 5 6 7 8
1
D1+
(TX+)
48
"Assembly of the device", page 30
"Product overview", page 39
1
1 2
Data (–)
"Assembly of the device", page 30
"Product overview", page 39
2 3
D1– D2+ D3+
(TX–) (RX+)
3
Data (+)
4 5 6
D3– D2–
(RX–)
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Installation | Connecting printers
4
GND
7 8
D4+ D4–