HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 173

Quick Start | Conducting a measurement
Constructing the zero point
The zero point is constructed of the point of intersection between the alignment
and the straight line.
Coordinate system of the measured object
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Select Construct in the function palette
A new feature is displayed in the feature list of the Inspector
Select Zero point in the geometry palette
Select the Alignment and Line features in the Inspector or in
the features view
The selected features are displayed in green
Tap Finish in the new feature
The zero point is created
The workpiece coordinate system for the measured object
has been determined
Select Manual measuring in the function palette
Tap Features preview
The coordinate system is shown in the workspace
9
173