HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 194

10
Capturing measuring points without a sensor
194
Tap Measure in the main menu
Select Manual measuring in the function palette
The workspace with the axis positions is displayed
Select Circle in the geometry palette
On the measuring machine, move to the desired position on
the measured object
If automatic measuring point acquisition is active, the
measuring point is captured automatically
Further information: "Setting automatic measuring point
acquisition", page 81
If automatic measuring point acquisition is not active, tap
Enter in the Inspector
A new feature appears in the feature list of the Inspector. The
symbol of the feature corresponds to the selected geometry
The number of captured measuring points is shown next to
the symbol
Position the second measuring point on the circular contour
Distribute the measuring points as evenly as
possible along the contour of the feature.
Measurement | Capturing measuring points
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016