HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 261

Measurement evaluation | Defining tolerances
Setting the tolerance limits manually
The tolerance limits can be adjusted manually to differ from the general tolerance
specified for the respective feature. The modified tolerance values apply only to
the currently open feature.
X
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
To switch between the Upper tolerance and Upper limit
input fields, tap Upper tolerance or Upper limit
Tap the Upper tolerance or Upper limit input field
Enter the desired value
Confirm entry with RET
The adjusted tolerance value is applied
Tap the Lower tolerance or Lower limit input field
Enter the desired value
Confirm entry with RET
The adjusted tolerance value is applied
The value is shown in green if the deviation of the actual
dimension is within the tolerance zone
The value is shown in red if the deviation of the actual
dimension is outside the tolerance zone
The display in the drop-down list switches to Manual after the
adjustment
Tap the symbol for size tolerance
The Tolerances tab is displayed
The result of the tolerance test is displayed on the tab and in
the feature list
11
261