HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 362

17
Error
The camera image
flickers.
Connection to the
network is not possible.
The connected USB
mass storage device is
not detected.
The device starts up in
recovery mode (text-
only mode).
User login is not
possible.
362
Error source Correction of fault
Incorrect pixel Set the pixel format in the
format selected camera settings
for the camera (see "Camera", page 318)
Defective Check the cable and the
connection correct connection to X116
Incorrect settings Check the network settings
of the network (see "Configuring the
network", page 142)
Defective Check the correct position of
connection the USB mass storage device
in the port
Use another USB port (X31 to
X34)
The type or Use another USB mass
formatting of storage device
the USB mass
storage device is
not supported
Software error If this fault occurs for the first
during startup time, switch the product off
and then on again
If the fault recurs, contact a
HEIDENHAIN service agency
Password does As a user with a higher
not exist authorization level, reset the
password
(see "Entering and configuring
users", page 138)
To reset the OEM password,
contact a HEIDENHAIN
service agency
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
What to do if ... | Troubleshooting
Personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel