HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 265

Measurement evaluation | Defining tolerances
Setting location tolerances
You can define the location tolerances for the following geometry parameters of a
feature:
Position for point, height point, line, circle, arc, ellipse, slot, rectangle and blob
Concentricity for circle and arc
The procedure for setting the position tolerances is the same for
all features. The following description shows how to set a location
tolerance for a circle with circular tolerance zone.
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Drag the feature from the feature list into the workspace
The Overview tab is displayed
Tap the Tolerances tab
The tab for tolerancing the selected feature is displayed
Tap Position
An overview of the selected position tolerance appears
The selection of position tolerance types is displayed
Further information: "Overview of position tolerance types",
page 255
Activate tolerancing of the measured value with the ON/OFF
sliding switch
The drop-down list with the selected General tolerance ISO
2768 or Decimal place tolerances is activated
11
265