HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 119

Commissioning | Commissioning steps
Setting a USB camera
Further information:
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Tap Settings in the main menu
Tap Sensors
Open in the sequence
Video edge detection (VED)
Camera
The list of available cameras is displayed
USB cameras are indicated by (USB) at the end of their name
Tap the USB camera you want to use
Tap Activate first, if necessary, to activate an inactive camera
The camera is activated
The first lines show the camera data
Select the desired pixel format in the Pixel format drop-
down list
Tap – or + to set the Pixel clock (MHz)
Tap – or + to set the Image rate
Tap – or + to set the Detail: Width
Tap – or + to set the Detail: Height
Tap – or + to set the Detail: X position
Tap – or + to set the Detail: Y position
Drag the slider to the desired position to adjust the Master
gain
Drag the slider to the desired position to adjust the Red gain
Drag the slider to the desired position to adjust the Green
gain
Drag the slider to the desired position to adjust the Blue gain
Tap – or + to set the Exposure time (µs)
The new camera settings are applied
"Camera", page 318
7
119