Date And Time - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

15

Date and time

15.3.6
Parameter
Date and time
Date format
Units
15.3.7
Parameter
Unit for linear values
Rounding method for linear
values
Decimal places for linear values
Unit for angular values
316
Explanation
Current date and time of the product
Settings: Year, Month, Day, Hour, Minute
Default setting: Current system time
Format in which the date is displayed
Settings:
MM-DD-YYYY: Month, day, year
DD-MM-YYYY: Day, month, year
YYYY-MM-DD: Year, month, day
Default setting: YYYY-MM-DD (e.g. "2016-01-31")
Explanation
Unit of measure for linear values
Settings: Millimeters or Inch
Default setting: Millimeters
Rounding method for linear values
Settings:
Commercial: Decimal places from 1 to 4 are rounded down,
decimal places from 5 to 9 are rounded up
Round off: Decimal places from 1 to 9 are rounded down
Round up: Decimal places from 1 to 9 are rounded up
Truncate: Decimal places are truncated without rounding up
or down
Default setting: Commercial
Number of decimal places for linear values
Setting range:
Millimeters: 0 ... 5
Inch: 0 ... 7
Default value:
Millimeters: 4
Inch: 6
Unit for angular values
Settings:
Radian: Angle in radian (rad)
Decimal degrees: Angle in degrees (°) with decimal places
Deg-Min-Sec: Angle in degrees (°), minutes ['] and seconds ["]
Default setting: Decimal degrees
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Settings | General