Recording A Measuring Program - HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual

Programming | Recording a measuring program
12.3

Recording a measuring program

All work steps of a measuring process are recorded. The work steps are displayed
as program steps in the program step list. You can use any work step for a
measuring program.
To start recording a new measuring program, proceed as described below.
Unsaved work steps are deleted before a new measuring program is
recorded.
...
12.4 Saving a measuring program
To be able to run a measuring process repeatedly, you need to save the executed
work steps as a measuring program.
...
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016
Tap Miscellaneous functions in the Inspector
In the Miscellaneous functions dialog, tap New
To delete existing program steps, confirm the message with
OK
All features and program steps are deleted
An empty feature list or a new program step list appears,
depending on the selection
Perform the measuring process on the measured object, e.g.
alignment of measured object, acquisition and evaluation of
features
All program steps are displayed in the program step list
Tap Miscellaneous functions in the Inspector
In the Miscellaneous functions dialog, tap Save as
Select the storage location in the dialog, e.g.
Internal/Programs
Enter a name for the measuring program
Confirm entry with RET
Tap OK
The measuring program is saved
The name of the measuring program is displayed on the
program control
12
275