HEIDENHAIN QUADRA-CHEK 3000 Operating Instructions Manual page 264

11
Setting the tolerance zone manually
The tolerance zone can be adjusted manually to differ from the general tolerance
specified for the respective feature. The modified tolerance value applies only to
the currently open feature.
264
Tap the Tolerance zone input field
Enter the desired value
Confirm entry with RET
The adjusted tolerance value is applied
The value of the tolerance zone is shown in green if the
deviation is within the tolerance zone
The value of the tolerance zone is shown in red if the
deviation is outside the tolerance zone
The display in the drop-down list switches to Manual after the
adjustment
Tap Roundness
The Tolerances tab is displayed
The result of the tolerance test is displayed on the tab and in
the feature list
Measurement evaluation | Defining tolerances
HEIDENHAIN | QUADRA-CHEK 3000 | Operating Instructions | 6/2016