Rep 10.7 Stack Full Sensor - Xerox Phaser 4600 Service Manual

REP 10.7 Stack Full Sensor

Parts List on PL 10.30 Item 9
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Remove the Duplex Unit, REP 10.1.
2. Remove the IP Board Cover, REP
3. Remove the Right Cover, REP 28.2.
4. Remove the Waste Toner Cartridge.
5. Remove the Left Cover, REP 28.3.
6. Remove the Top Cover, REP 28.5.
7. Remove 5 screws (2 plastic, 3 metal) that secure the rear support bracket to the chassis.
8. Lift the bracket and rest on the printer chassis,
Figure 1 Remove the rear support bracket
9. Remove 4 screws (plastic) that secure the Exit Chute to the chassis.
Revised
Phaser 4600/4620/4622 Printer Service Manual
WARNING
28.1.
Figure 1.
10. Lift the chute and rest on the support bracket,
Figure 2 Remove the Exit Chute
11. Disconnect P/J27 from the Stack Full Sensor.
12. Release 3 hooks that secure the sensor to the Exit Chute,
04/2016
4-93
Figure 2.
Figure 3.
4 Repairs and Adjustments
REP 10.7