Hummer H3T Owner's Manual page 108

04AKENG59_H3T.fm Page 108 Thursday, July 31, 2008 12:07 PM
Instrumentation and Controls
In light rain or snow, you can use
the delay feature. Turn the band to
one of the delay settings to choose
the desired delay time between
sweeps. The closer the setting is to
the top of the lever, the shorter the
delay.
. . . 108
To turn off the wipers, rotate the
band to the "off" setting .
In order for this feature to work,
the ignition must be on or
Retained Accessory Power must be
active.
See the following, later in this
section, for more information:
• Retained Accessory Power
The wipers are protected by a
circuit breaker and a fuse. If there
is an electrical overload, the wiper
system will stop until the motor
cools.
Clear any ice or snow from the
wiper blades before using them to
prevent damage to the blades and
overloading the wiper motor.
Wiper blades will eventually wear
out and not wipe properly, reduc-
ing forward vision. Replace worn
wiper blades.