Operational Safety - Fuji Xerox DocuCentre-II 2055 User Manual

1 Before Using the Machine
1

Operational Safety

20
Never locate the equipment:
Near Radiator or any other heat source
Near volatile, flammable or combustible materials such as curtains
In a hot, humid, dusty or poorly ventilated environment
In a place receiving direct sunlight
Close to a cooker or humidifier that emits oily fumes or steam
Place the machine on a level and sturdy surface that can withstand a weight of
146 Kg. If tilted, the machine may fall over and cause injuries.
Do not incline the product more than 10 degrees.
When the machine is installed, be sure to lock the caster stoppers. An
unlocked machine may fall over or slide and cause injuries.
In order to use and maintain this product in a good performance and condition,
make sure to use the product within the following environment:
Temperature: 10 32 °C
-
Humidity: 35 85%
-
When the product is left in a freezing cold room and the room is rapidly warmed
up by heater, it can generate water drops inside the machine and cause a
partial deletion on printing.
Any operator product maintenance procedures will be described in the
customer documentation supplied with the product. Do not carry out any
maintenance procedures on this product which are not described in the
customer documentation.
This equipment has been designed to restrict operator access to safe areas
only. Operator access to hazardous areas is restricted with covers or guards,
which would require a tool to remove. Never remove these covers or guards.
If any of the following conditions occur, switch off the power to the machine
immediately and disconnect the power cord from the electrical outlet. Call an
authorized local service representative to correct the problem.
The equipment emits smoke or a surface of the equipment becomes
unusually hot.
The equipment emits unusual noises or odors.
The power cord is damaged or frayed.
A wall panel circuit breaker, fuse, or other safety device has been tripped.
Liquid has spilled into the equipment.
The equipment is exposed to water.
Any part of the equipment is damaged.