Fuji Xerox DocuCentre-II 2055 User Manual page 571

Active Area 161
Determining
Command
Paper Margin 162
Image 163
Enhancement
Stapling 164
Manual Feed 165
Tray Check
Indicator
Pen Width 800-815
(No. 0-No.15)
Line End Shape 850-865
(No. 0-No.15)
0 (Default): Auto
1: PS
2: IW
3: IP
4: Adapted
When auto-scaling is in use, this sets the method for obtaining the active
coordinate area.
[Auto]...Determines any of the methods listed below: PS, IW, IP, or
Adapted.
[PS]...Area specified by the first PS command is to be a rectangular area.
[IW]...Area specified by the very last IW command is to be a rectangular
area.
[IP]...Area which combines all the IP commands is to be a rectangular
area.
[Adapted]...The maximum/minimum coordinates within the areas and
coordinates plotted using the drawing command, and the maximum size
of characters and line width specified in the page, are used to calculate
the rectangular area.
0 to 99 (Default): 0): 0 - 99 mm
Sets the paper margin when auto scaling is being used.
0: OFF
1 (Default): ON
Sets whether to artificially increase the resolution of an image and smooth
its edges.
0 (Default): None
1: Top Left
2: Top Double
3: Top Right
4: Left Double
5: Right Double
6: Bottom Left
7: Bottom Double
8: Bottom Right
9: Center
Sets the stapling position.
0: None
1 (Default): Yes
0 to 255 (Default): 3): 0 to 25.5 mm
Sets the width of the pen (thickness of the line).
Width units are 0.1 mm. Can be set in steps of 0.1 mm.
0 (Default): Cut
1: Round
2: Rectangular
Sets the line end shape.
HP-GL2 Emulation
17
569