Fax Signal Method - Fuji Xerox DocuCentre-II 2055 User Manual

Fax Signal Method

1
Select an address number or group dial number to which a relay broadcast is
registered and press the <Start> button.
To perform Multiple Relay Broadcast, repeat this step.
DTMF Method
There are two methods in the DTMF method: Auto Send and Manual Send.
Auto Send (transmitting without picking up the receiver)
1
Select [Keyboard] to display the keyboard on the touch screen and enter the following
format.
2
Select [Next Recipient] to perform Multiple Relay Broadcast.
Note • You can specify up to 20 locations for relay recipients.
Password
A pre-registered two-digit number
Note • By default, no password is set. For setting a password, contact our Customer Support
Relay station ID
The last two digits of the initiating station address number registered at the relay
station.
Address number
An address number for the relay recipients registered at the relay station.
The wildcard "∗" can also be used.
Note • The above dialing format can be registered in an address number to send using the address
3
Press the <Start> button.
Manual Send (transmitting with picking up the receiver or on-hook)
1
Select the [Advanced Features] tab
to display the [Advanced Features]
screen.
2
Select [On-hook (Manual Send/
Receive)].
3
Select [Manual Send] from the
drop-down menu.
4
Use the keyboard shown in the
touch screen to enter numbers in
the following format.
Center. If a password has not been set, you do not need to enter one.
number. For information on how to register address numbers, refer to "Address Book"
(P.343).
Broadcast
4
153