Fuji Xerox DocuCentre-II 2055 User Manual page 468

16 Problem Solving
Error Code
012-254
012-260
012-263
012-267
012-282
012-283
012-284
012-291
012-293
012-294
012-295
012-296
016-210
016-211
016-213
016-214
016-217
016-219
016-229
16
016-230
016-450
016-454
016-455
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
466
Category
C P F S M O
O [Cause]
[Remedy] If there is any foreign object under the finisher tray, remove it
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
O [Cause]
[Remedy] Turn the machine off and on. If the machine conditions are
O [Cause]
[Remedy] Take one of the following actions:
For information on how to set the host name, refer to "Machine's E-mail
Address/Host Name" (P.300).
O [Cause]
[Remedy] Check the DNS configuration and IP address retrieve
Refer to the Network Administrator Guide for details.
O [Cause]
[Remedy] Check the network cable connection and the IP address of
Refer to the Network Administrator Guide for details.
Cause and Remedy
The sensor was activated because paper output to the
finisher was removed before the finisher tray lowered and
completely stopped in position. Or, there is a foreign object
under the finisher tray.
and then turn the machine off and on. If the error persists,
contact our Customer Support Center.
Finisher malfunction
not improved by performing the relevant remedy, contact
our Customer Support Center.
Software error
not improved by performing the relevant remedy, contact
our Customer Support Center.
A computer with the same host name may exist on the
network.
1) Check whether a computer with the same host name
exists on the network. If it does, change the host name of
either the machine or the other computer.
2) If you cannot check it, change the host name of the
machine.
Unable to retrieve the IP address from DNS.
setting.
Connection to the SNTP server was timed out.
the SNTP server.