Fuji Xerox DocuCentre-II 2055 User Manual page 511

Category
Error Code
C P F S M O
035-743
O
035-744
035-745
035-746 O
035-747 O
035-748
035-749
O
035-750
O
035-751 O
035-752
035-753
O
035-754
O
035-755
035-756
035-757
035-758
035-759
035-760
035-761
035-762
036-500
036-501
036-502
036-503
036-504
036-505
036-506
036-507
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
Cause and Remedy
[Cause] Unable to communicate. The phone number is incorrect or
the destination machine does not have the feature you
specified.
[Remedy] Check the destination phone number, check also if the
destination machine has the feature you specified, and
then try again.
[Cause] The fax network does not respond.
This may be caused by the following. Check them and
then send the fax again.
[Remedy] Is the telephone line correctly connected?
You may not have a fax network contract, or the fax
network may have a problem.
When connecting the machine to the fax network, enter
two pauses after "161" and "162", then dial the telephone
number.
[Cause] The dialing or transmission was interrupted by the <Stop>
button.
[Remedy] No action is necessary.
[Cause] The number was re-dialed the specified number of times,
but the destination machine did not respond.
[Remedy] Ask the recipient if the telephone line and telephone
switchboard for the destination machine are defective.
Refer to 034-508.
[Cause] The dialing or transmission was interrupted by the <Stop>
button.
[Remedy] No action is necessary.
[Cause] Memory became insufficient when attempting to receive
more than 999 pages of fax document.
[Remedy] Ask the sender to reduce the number of pages at one
transmission.
[Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the error persists, contact
our Customer Support Center.
Error Code
16
509