Table of Contents
Advertisement
FB Edge Erase
This setting sets the size of the no‑print area around a flatbed scan job.
1
Enter the Configuration menu, and then select FB Edge Erase.
2
Select a setting.
3
Apply the changes.
Scanner Manual Registration
Use this setting to register the flatbed and ADF on the scanner. Perform a registration adjustment whenever the ADF,
flatbed, or controller board is replaced.
Note: This setting does not appear if the Disable Scanner setting is set to Auto Disabled.
Enter the Configuration menu, and then select Scanner Manual Registration.
For more information on adjusting the scanner registration, see
"Flatbed registration adjustment" on page
Disable Scanner
Use this setting to disable the scanner if it is not working properly.
1
Enter the Configuration menu, and then select Disable Scanner.
2
Select a setting, and then apply the changes.
3
Reset the printer.
Paper Prompts
This setting determines the input source to which the printer directs a paper change prompt.
Note: The value of
"Action for Prompts" on page 234
1
Enter the Configuration menu, and then select Paper Prompts.
2
Select a setting.
3
Apply the changes.
Envelope Prompts
This setting determines the input source to which the printer directs an envelope change prompt.
Note: The value of
"Action for Prompts" on page 234
1
Enter the Configuration menu, and then select Envelope Prompts.
2
Select a setting.
3
Apply the changes.
"ADF registration adjustment" on page 259
261.
may override the value of this setting.
may override the value of this setting.
Service menus
233
7421
and
Advertisement
Table of Contents
