3000-Sheet Tray Pick Roller Pressure Adjustment - Lexmark MX910de Service Manual

Notes:
•
Make sure that the belt tension is not too loose or too tight.
•
Make sure that the drive belt is kept tight by the spring.
3
Turn the drive gear.
4
Tighten the three screws (D).
Note: Make sure that the belt tension is not too loose or too tight.
3000‑sheet tray pick roller pressure adjustment
Jams may occur if the improper level of pressure is applied when picking thin paper. Perform this procedure to increase
the pick roller pressure.
1
Remove the screw (A), and then remove the plates.
Installation note: Replace this screw with an M3 x 10 mm screw.
Repair information
268
7421