Reports; Event Log - Lexmark MX910de Service Manual

Restoring backup data when replacing the engine controller board
1
Before removing the old engine controller board, select Engine card to controller card to move the current engine
settings into the controller board.
2
After installing the new engine controller board, select Controller card to engine card to move the engine board
settings stored on the controller board to the new engine controller board.
Reset Fuser Counter
This setting resets the fuser counter to zero.
Note: This setting appears only if the Maintenance Warning and Intervention configuration ID bit is enabled.
Enter the Diagnostics menu, and then navigate to:
PRINTER SETUP > Reset Fuser Counter

REPORTS

Menu Settings Page
This report shows the Diagnostics menu settings and their current values.
Enter the Diagnostics menu, and then navigate to:
REPORTS > Menu Settings Page
Installed Licenses
This report shows the installed licenses and their features.
Enter the Diagnostics menu, and then navigate to:
REPORTS > Installed Licenses

EVENT LOG

Display Log
This setting displays the panel text that appears when the event occurs.
Enter the Diagnostics menu, and then navigate to:
EVENT LOG > Display Log
Print Log
This setting prints the various printer events.
Note: The events that appear in the report vary depending on the operational history of the printer.
Enter the Diagnostics menu, and then navigate to:
EVENT LOG > Print Log
Service menus
226
7421