7
Remove the screw (A), and then remove the guide.
8
Disconnect the cable (B), and then remove the four screws (C).
9
Slightly lift the motor to release, and then remove it.
Fuser drive gearbox removal
1
Remove the port access door. See
2
Remove the scanner interface cable cover. See
3
Remove the controller board access cover. See
4
Remove the engine board cover. See
"Port access door removal" on page
"Scanner interface cable cover removal" on page
"Controller board access cover removal" on page
"Engine board cover removal" on page
Repair information
385
278.
346.
7421
344.
345.