Table of Contents
Advertisement
3
Open the bottom front door and right door.
4
Select Registration.
5
Press X three times.
6
Close the bottom front door and right door.
Note: If the engine does not initialize, then the motor test is in safe mode.
7
Select a motor.
8
Check if the motor runs.
Note: Not all motors run the same way.
The following motors run, and then stop after a preset duration:
•
MPF tray lift-up plate elevator down
•
Tray 1 lift
•
Tray 2 lift
•
Fusing pressure release
The following motors continuously run, unless the test is canceled:
•
Registration
•
Paper feed
•
Tray 2 vertical transport
•
Polygon
•
Transport
•
Fusing
•
Developing
•
Duplex transport
•
Redrive forward
•
Redrive reverse
2x500‑Sheet Tray Motor Tests
These tests verify that the 2 x 500‑sheet tray motors are properly working.
Note: If these tests are not performed in safe mode, then the control panel may become unresponsive.
1
Enter the Diagnostics menu, and then close the bottom front door.
2
Navigate to:
Motor Tests > PRINTER MOTOR TESTS
3
Open the bottom front door and right door.
4
Select Registration.
5
Press X three times.
6
Close the bottom front door and right door.
Note: If the engine does not initialize, then the motor test is in safe mode.
Service menus
220
7421
Advertisement
Table of Contents
