Fb Edge Erase; Scanner Manual Registration - Lexmark 363dn Service Manual

7013-XXX

FB Edge Erase

This menu item sets the size, in millimeters, of the no print area around a flatbed scan job. Copy jobs will use the
setting or two millimeters, whichever is larger.
To adjust the flatbed edge erase setting, perform the following steps:
1.
In the Configuration menu, select the FB Edge Erase menu item.
2.
Use the
3.
When the desired value is displayed, press

Scanner Manual Registration

This item is used to manually register the flatbed and ADF on the MFP's scanner unit. Registration should be
performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually register the ADF perform the following steps:
1.
In the Configuration Menu, scroll to the Scanner Manual Registration menu item.
2.
Press .
3.
Scroll to the Print Quick Test Page menu item.
4.
Press .
5.
To view and adjust the simplex ADF registration, place the quick test page into the ADF, scroll to the Copy
Quick Test Page item, and press
6.
After the quick test page copies, scroll to ADF and press
7.
Scroll to Horizontal Adjust, and press
8.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
9.
Press
10.
Scroll to Top Edge, and press
11.
Use the
Note: Pressing
12.
Press
To manually register a Duplex ADF, perform the following steps:
1.
In the Configuration Menu, scroll to the Scanner Manual Registration menu item.
2.
Press .
3.
Scroll to the Print Quick Test Page menu item.
4.
Press .
5.
To view and adjust the duplex ADF front side registration, place the quick test page faceup into the ADF,
scroll to the Copy Quick Test Page item, and press
6.
After the quick test page copies, scroll to ADF Frontside, and press
7.
Scroll to Horizontal Adjust, and press
8.
Use the
Note: Each button press moves the margin values one pixel in the respective direction.
9.
Press
10.
Scroll to Top Edge, and press
11.
Use the
Note: Pressing
12.
Press
13.
To view and adjust the duplex ADF backside registration, place the quick test page facedown up into the
ADF, scroll to the Copy Quick Test Page item, and press
14.
After the quick test page copies, scroll to ADF Backside, and press
15.
Scroll to Horizontal Adjust, and press
3-30
Service Manual
or to increase or decrease the setting's value.
.
or to increase or decrease the setting's value.
to accept the value.
.
or to increase or decrease the setting's value.
moves the margin up, and pressing
to accept the value.
or to increase or decrease the setting's value.
to accept the value.
.
or to increase or decrease the setting's value.
moves the margin up, and pressing
to accept the value.
.
.
.
moves the margin down.
.
.
moves the margin down.
.
.
.
.