Table of Contents
Advertisement
•
Update the network firmware in the printer or print server. For more information, go to
http://support.lexmark.com.
Not enough free space in flash memory for resources [52]
Try one or more of the following:
•
From the control panel, touch Continue to clear the message and continue printing.
•
Touch Reset active bin to reset the active bin for a linked set of bins.
•
Delete fonts, macros, and other data stored in the flash memory.
•
Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.
Open door H and remove paper from beneath area H10
Remove the paper from the specified area.
Paper changes needed
Try one or more of the following:
•
Touch Use current supplies to clear the message and continue printing.
•
Cancel the current print job.
Parallel port [x] disabled [56]
Try one or more of the following:
•
From the printer control panel, touch Continue to clear the message.
•
Enable the parallel port. From the printer control panel, navigate to:
Network/Ports > Parallel [x] > Parallel Buffer > Auto
Note: The printer discards any data received through the parallel port.
Photoconductor low [84.xy]
You may need to order a replacement photoconductor. If necessary, select Continue on the control panel to clear the
message and continue printing.
Photoconductor very low [84.xy]
You may need to replace the photoconductor unit very soon.
If necessary, touch Continue on the control panel to clear the message and continue printing.
Printer had to restart. Last job may be incomplete.
From the printer control panel, touch Continue to clear the message and continue printing.
Diagnostic information
127
7421
Advertisement
Table of Contents
