Table of Contents
Advertisement
Actions
Step 7
Enter the Diagnostics menu, and then navigate to:
SENSOR TESTS > 2500-Sheet Tray Sensor Tests
Does the sensor status change while toggling the sensor?
Step 8
a
Make sure that the sensor cables are properly installed.
b
Make sure to route the cables properly.
c
Make sure to reseat the cables on the 2500-sheet tray controller board
and the sensors.
d
Make sure to reseat the junction connectors of the cables.
e
Make sure that the cables do not snag on moving objects.
f
Check the cables for damage, and replace if necessary.
Does the problem remain?
Step 9
a
Remove the tray insert.
b
Make sure that the sensor (transfer guide home) and sensor (2500-
sheet tray elevator home) are properly installed.
c
Check the sensors for damage, and replace if necessary. See
(2500‑sheet tray transfer guide home) removal" on page 470
"Sensor (2500‑sheet tray elevator home) removal" on page
Does the problem remain?
600 errors
600 error messages
Error code
Description
600.00
The image was not ready during a print job from the
MPF.
600.01
The image was not ready during a print job from tray
1.
600.02
The image was not ready during a print job from tray
2.
600.03
The image was not ready during a print job from tray
3.
600.04
The image was not ready during a print job from tray
4.
600.05
The image was not ready during a print job from tray
5.
600.10
The image was not ready during a duplex print job.
Yes
Go to step 9.
Go to step 9.
Contact the next level
of support.
"Sensor
and
465.
Action
See
"Unready image service check" on page
Diagnostic information
180
7421
No
Go to step 8.
The problem is solved.
The problem is solved.
181.
Advertisement
Table of Contents
