Table of Contents
Advertisement
•
Hold the parts by their edge connector shroud. Do not touch its pins. If you are removing a pluggable module, then
use the correct tool.
•
If possible, keep all parts in a grounded metal cabinet.
•
Do not place the parts on the printer cover or on a metal table. If you need to put down the parts, then put them
into their packing material.
•
Prevent parts from being accidentally touched by other personnel. Cover the printer when you are not working on
it.
•
Be careful while working with the parts when cold-weather heating is used. Low humidity increases static electricity.
Restoring the printer configuration after replacing the controller board
Restore the printer to its correct configuration to complete the replacement service. Use the Service Restore Tool to
download the software bundle, and then flash the printer settings and Embedded Solutions.
Note: The software bundle contains the latest version of the firmware, applications, and software licenses from the
Lexmark Virtual Solutions Center (VSC). The printer firmware may be at a different level from what was used before
replacing the controller board.
Using the Service Restore Tool
1
Go to
https://cdp.lexmark.com/service-restore-tool/
2
Log in using your Lexmark or partner login.
If your login fails, then contact your next level of support.
3
Enter the printer serial number, and then submit the information.
Note: Make sure that the serial number that appears on the verification screen is correct.
to access the tool.
Repair information
242
7421
Advertisement
Table of Contents
