Lexmark MX910de Service Manual page 110

Error code Description
283.11 The paper remains detected at the sensor
(ADF scan) after the printer is turned on.
283.12 The paper was detected earlier than
expected at the sensor (ADF scan).
283.13 The sensor (ADF scan) did not detect the
paper after registration.
283.15 The paper remains detected at the sensor
(ADF scan) during a job.
ADF registration jam service check
Actions
Step 1
Enter the Diagnostics menu, and then navigate to:
EVENT LOG > Display Log
Does the error log show persistent 280.x1 jam?
Step 2
Clear the sensor (ADF document separation) and sensor (ADF registration)
paper paths of debris or dust.
Does the problem remain?
Step 3
Check the sensor actuators for damage, and replace if necessary.
Does the problem remain?
Step 4
Enter the Diagnostics menu, and then navigate to:
SCANNER TESTS > Sensor Test
Does the sensor status change while toggling the sensor?
Step 5
a
Reseat the sensor cables.
b
Check the cables for damage, and replace if necessary.
Does the problem remain?
Step 6
Check the sensor (ADF document separation) and sensor (ADF
registration) for damage, and replace if necessary. See
open cover section) removal" on page
Does the problem remain?
Action
See "ADF scan jam service check" on page
"Sensors (ADF top
425.
Diagnostic information
110
Yes No
Go to step 2. Go to step 7.
Go to step 3. The problem is solved.
Go to step 4. The problem is solved.
Go to step 7. Go to step 5.
Go to step 6. The problem is solved.
Go to step 7. The problem is solved.
7421
116.