NumPad Job Assist
When this setting is set to On, a user can initiate scanner-related jobs, and enter values for a limited number of settings
related to those jobs, using the keypad.
Touch Back to exit without changing the setting.
Format Fax Storage
This setting enables you to format the non-volatile storage used for storing faxes.
Note: If an advanced password has been established, you must enter this password in order to change the setting.
Fax Storage Location
This menu allows you to select either NAND or the printer hard disk (Disk) as the fax storage location. If the printer
hard disk is removed, then this menu no longer appears.
1
In the Color Alignment sub menu, select A.
2
Look at item A on the sheet.
3
Look for the numerical value where the color lie is aligned with the two black lines on each end.
Note: In the example above, 10 would be the value to enter.
4
Using the arrows on the touch screen, scroll to the value that matches the correct value on the printout.
5
Touch the check mark.
6
Repeat steps 3 through 6 for each alpha value on the printout.
ADF Edge Erase
The ADF Edge Erase setting specifies, in millimeters, the size of a border around the scanned image that will be erased.
For copies, the printed page will always have at least a 2-mm no-print border. The larger of the 2-mm no-print border
and the Edge Erase setting will be used in this situation.
FB Edge Erase
The FB Edge Erase setting specifies, in millimeters, the size of a border around the scanned image that will be erased.
For copies, the printed page will always have a at least a 2-mm no-print border. The larger of the 2-mm no-print border
and the Edge Erase setting will be used in this situation.
Scanner Manual Registration
Use this menu to adjust the scanner margins after you replace any of the following parts:
•
Flatbed scanner assembly
•
Front ADF scanner assembly
•
Back ADF scanner assembly
Note: The Scanner Manual Registration menu does not appear if Disable Scanner is set to Auto Disabled.
Service menus
44
4036