Fax Storage Location; Adf Edge Erase; Fb Edge Erase; Scanner Manual Registration - Lexmark X746de Service Manual

7526

Fax Storage Location

This setting only appears if a hard disk is installed. Selections are NAND or Disk.
Touch Fax Storage Location from the Configuration Menu.
1.
Touch the
2.
3. Touch Submit.
Note: If a hard disk is not installed, the multiple function printer automatically stores all buffered faxes on NAND,
and this menu does not appear. Disk is the default storage location.

ADF Edge Erase

The value of this setting determines the size (in millimeters) of the "no-print" zone around an ADF scan job. A
copy job always has at least a 2mm border; therefore, the border size is either 2mm or the value of this setting,
whichever is larger.
To change the value for ADF Edge Erase:
Touch ADF Edge Erase from the Configuration Menu.
1.
Touch the
2.
3. Touch Submit.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

FB Edge Erase

The value of this setting determines the size (in millimeters) of the "no-print" zone around an ADF scan job. A
copy job always has at least a 2mm border; therefore, the border size is either 2mm or the value of this setting,
whichever is larger.
To change the value for FB Edge Erase:
Touch FB Edge Erase from the Configuration Menu.
1.
Touch the
2.
Touch Submit.
3.
Submitting changes... is displayed.
You are automatically returned to the Configuration menu.

Scanner Manual Registration

This item is used to manually register the flatbed and ADF on the MFP scanner unit. Registration should be
performed whenever the ADF unit, flatbed unit, or controller card are replaced.
To manually adjust the scanner:
Touch Scanner Manual Registration.
1.
2. Touch Print Quick Test.
Place the quick test on the glass of the flatbed scanner.
3.
Press Copy Quick Test.
4.
Select Flatbed.
5.
Service Manual
3-36
or arrow to toggle between NAND and Disk.
or arrows to change the value from 0 to 6 (3 is the default).
or arrows to change the value from 0 to 6 (3 is the default).
Previous
Next
Go Back