Memory Full, Cannot Print Faxes; Memory Full, Cannot Send Faxes; No Analog Phone Line Connected To Modem, Fax Is Disabled; Network [X] Software Error [54] - Lexmark MS911 Service Manual

Memory full, cannot print faxes

From the printer control panel, touch Continue to clear the message without printing. Held faxes attempt to print after
the printer is restarted.

Memory full, cannot send faxes

1
From the printer control panel, touch Continue to clear the message and cancel the fax job.
2
Try one or more of the following:
•
Reduce the fax resolution, and then resend the fax job.
• Reduce the number of pages in the fax, and then resend the fax job.

No analog phone line connected to modem, fax is disabled.

Connect the printer to an analog phone line.

Network [x] software error [54]

Try one or more of the following:
•
From the printer control panel, touch Continue to continue printing.
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark support Web
site at http://support.lexmark.com.

Not enough free space in flash memory for resources [52]

Try one or more of the following:
• From the control panel, touch Continue to clear the message and continue printing.
•
Touch Reset active bin to reset the active bin for a linked set of bins.
•
Delete fonts, macros, and other data stored in the flash memory.
• Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.

Open door H and remove paper from beneath area H10

Remove the paper from the specified area.

Paper changes needed

Try one or more of the following:
•
Touch Use current supplies to clear the message and continue printing.
•
Cancel the current print job.
Diagnostic information
43
4021, 7421