Toshiba E-studio 210c Imaging Manual page 80

3. Printer-specific Adjustments
For Macintosh
Open the print settings dialog box and change the "CMYK Simulation Method" settings to "Full (Source
GCR)" or "Quick".
* A menu to be selected depends on a combination between printer controller and OS. For the combination,
refer to the table below.
Controller
GA-1120
GA-1130
GA-1121
GA-1131
Cautions after the completion of the adjustment
• The adjustment may possibly cause poor reproducibility of fine gray lines and light gray areas, a dark gray area
to be blurred, and an entire print image to look rough containing black (because of K toner positively used).
Therefore, perform the adjustment carefully, while checking the printout.
• When "CMYK Simulation Method" is set to "Quick", each of C, M, or Y color is reproduced with its toner's
original color. This causes change in color balance. When it is set to "Full (Source GCR)", the color balance
of C, M, or Y color is almost the same as that of the default due to ink simulation. These should be considered
when making this adjustment.
3.4
e-STUDIO210c/310c, e-STUDIO211c/311c
OS
OS 9.x "Printer Specific Options"
OS 9.x "ColorWise" "CMYK Simulation Method"
"Printer Features"
OS X
Method"
OS 9.x "Printer Specific Options"
"Printer Features"
OS X
Method"
Menu
"CMYK Simulation Method"
"Feature Sets: ColorWise 2"
"CMYK Simulation Method"
"Feature Sets: ColorWise 2"
"CMYK Simulation
"CMYK Simulation