Toshiba E-studio 210c Imaging Manual page 53

(1) Select the "PROGRAM" menu from the Control Panel, select "Bypass", then "Special paper".
Set the special paper on the bypass guide.
After the setting, make a copy and check the image quality.
If further image quality adjustments are still necessary, use the next procedure.
(2) Make the color balance adjustment or RGB adjustment to adjust the colors in general.
• Follow procedures (a) through (d) to make the adjustment.
(a) Select the "COLOR" menu from the Control Panel.
(b) Select "COLOR BALANCE" for adjustment with YMCK, and "RGB ADJUSTMENT" for
adjustment with RGB.
(c) Select a "+" position to enhance the tint of the color, and a "−" position to decrease the tint of the
color.
(d) Press the [SET] button.
<Hint> Generally, the colors of the copy made on waterproof glossy POP paper is darker than those of the
original paper. Generally, it is recommended to set the colors to the [−] side.
After adjusting the colors, make a copy and check the image quality.
If further image quality adjustments are still necessary, use the next procedure.
(3) Enter adjustment mode [05] and change the value for code [609] to adjust the amount of toner to be adhered
on special paper.
• Increase the value until the image density, required by Special paper mode, is obtained while considering
the balance with the toner transferability and fusibility.
Paper mode [05] code
Special paper
* Set the value in increments of about 4 while checking the copy until the optimum value is obtained.
* Applicable paper thickness in Special paper mode is listed below.
Paper mode
Special paper
Cautions after the completion of the adjustment
Nothing in particular.
Remarks
• Enter the value within the recommended value range mentioned in the procedures. Otherwise, it may cause a
loss in copier performance, including image failure and a decrease in consumable life.
• If the adjustment causes a problem with the fixing of toner, lower the set value for 05-609 for adjustment.
Value recommended
05-609 241 to 255
Applicable paper thickness
Recommended waterproof gloss paper for POP
(Equivalent to AquaAce manufactured by Verbatim.)
2. Copier-specific Adjustments
Default
249
e-STUDIO210c/310c, e-STUDIO211c/311c
2.13