Toshiba E-studio 210c Imaging Manual page 24

1. General Adjustments – Copying and Printing
(2) Check the life in consumables (particularly the drum, developer material and transfer belt unit), and replace
if necessary.
* When any consumable parts are replaced, follow procedures (a) and (b) below.
(a) Enter adjustment mode [05], select code [879], and press the [START] button.
• Image quality control will take place and the image quality control value will be initialized.
(b) Perform automatic calibration (γ adjustment) and calibration.
* For the adjustment method, refer to procedure (2) in Section 1.1 "To Obtain High-density Image in
General".
* When a drum is replaced, reset the values of the drum life counter and the drum drive counter for the
replaced color to zeros.
Drum life counter
Replaced drum
Y
M
C
K
* When any consumable parts are replaced, also check the slit glass of the laser optical unit, and thoroughly
clean if found fouled.
Cautions after the completion of the adjustment
The adjustment may possibly cause slowdown in the copying or printing speed and loss in consumable life.
Therefore, perform the adjustment carefully, while checking the printout.
Remarks
• Enter the value mentioned in the procedures. Otherwise, it may cause a loss in copier performance, including
slowdown in the copying or printing speed.
• When replacing any consumable parts, refer to the relevant information in the SERVICE MANUAL and
SERVICE HANDBOOK.
1.5
e-STUDIO210c/310c, e-STUDIO211c/311c
Drum drive counter
[08] code
08-840
08-841
08-842
08-843
Replaced drum [08] code
Y 08-867
M 08-868
C 08-869
K 08-870