Toshiba E-studio 210c Imaging Manual page 21

(2) Enter setting mode [08] and change the set value for code [453] to reduce the number of sheets for
continuous printing at which image quality control is executed.
* The value should be set in the range of "10" to "200" to meet the number of sheets to be continuously
printed by the user and the stability of the desired image quality.
Value for 08-453 Continuously printed number of sheets at which image quality control is executed
"10" to "200"
300
After changing the set value, print and check the image quality.
If further image quality adjustments are still necessary, use the next procedure.
(3) Check the life in consumables (particularly the drum, developer material and transfer belt unit), and replace
if necessary.
* When any consumable parts are replaced, follow procedures (a) and (b) below.
(a) Enter adjustment mode [05], select code [879], and press the [START] button.
• Image quality control will take place and the image quality control value will be initialized.
(b) Perform automatic calibration (γ adjustment) and calibration.
* For the adjustment method, refer to procedure (2) in Section 1.1 "To Obtain High-density Image in
General".
* When a drum is replaced, reset the values of the drum life counter and the drum drive counter for the
replaced color to zeros.
Drum life counter
Replaced drum
Y (yellow)
M (magenta)
C (cyan)
K (black)
* When any consumable parts are replaced, also check the slit glass of the laser optical unit, and thoroughly
clean if found fouled.
Cautions after the completion of the adjustment
The adjustment may possibly cause slowdown in the copying or printing speed and loss in consumable life.
Therefore, perform the adjustment carefully, while checking the printout.
Remarks
• Enter the value mentioned in the procedures. Otherwise, it may cause a loss in performance, including
slowdown in the copying or printing speed and a decrease in consumable life.
• When replacing any consumable parts, refer to the relevant information in the SERVICE MANUAL and
SERVICE HANDBOOK.
Executed every 10 to 200 sheets
Executed every 300 sheets (default)
Drum drive counter
[08] code
08-840
08-841
08-842
08-843
1. General Adjustments – Copying and Printing
Replaced drum [08] code
Y (yellow) 08-867
M (magenta) 08-868
C (cyan) 08-869
K (black) 08-870
e-STUDIO210c/310c, e-STUDIO211c/311c
1.4