Pseudo-Photo Gradation Mode - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

5 Tools
Note
Edge Erase - Top & Bottom Edges
Specify an amount of border erased from the original in the top and bottom directions. You
can specify a value within the range from 0 to 20 mm in 1 mm increments.
Edge Erase - Left & Right Edges
Specify an amount of border erased from the original in left and right directions. Specify a
value in the range from 0 to 20 mm, in 1 mm increments.
Reduce 8.5 x 11"
When [Reduce/Enlarge] in the [Layout Adjustment] screen is set to [Auto %], you can set
whether to reduce 8.5 x 11"

Pseudo-Photo Gradation Mode

You can set the toning method for photo originals. To get closer to photo image quality, select
the handling of intermediate tones (gray). You can select from [Error Diffusion] and [Dither].
Mailbox Selector Setup
Select whether to use the Mailbox Selector Setup feature.
5
The Mailbox Selector Setup feature allows you to classify received documents by line type
and store them in specified mailboxes.
Memory Full Procedure
When the space of the hard disk runs out during scanning originals, a screen appears asking
how the partly stored data should be handled.
Once a certain time has elapsed with the confirmation screen displayed, the subsequent
processing is determined by these settings.
You can set the time until the memory full procedure is carried out. For more information, refer to "Auto
Job Release" (P.124).
Delete Job
The stored data is discarded.
Run Job
The stored fax data is printed.
Maximum Stored Pages
Set the maximum number of fax pages that the machine can store. You can specify a value in
the range of 1 to 999.
Mailbox Receive Display Priority 1 to 5
Set the priority to display the fax document information received using mailboxes. For
instance, when using Network Scanner Utility3, the fax information is displayed in the
[Recipient] section of the document list screen.
There are the priority levels from 1 to 5. All priority can be set, however, if you want to display
only one priority level, make the settings of all priority levels the same.
Note
Direct Fax
Set whether to allow the use of Direct Fax. When selecting [Disabled], the Direct Fax feature
cannot be used.
192
• This feature does not appear for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
• Even if you select [On], depending on the data, 2-sided printing may not always be possible.
Original to A4
size to A4
• This feature is not available for some models. An optional package is necessary. For more
information, contact our Customer Support Center.
, while scanning the original.