Ipsec Settings - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

5 Tools
PDF/DocuWorks/XPS Signature Settings (ApeosPort Series Models Only)
Allows you to make the settings for security and signature of PDF/DocuWorks/XPS
documents.
Device Certificate
Select a certificate to be linked.
For information on the certificate, refer to "Encryption and Digital Signature Settings" (P.313).
PDF Signature
Select the setting for PDF Signature from [Do not add signature], [Always add visible
signature], [Always add invisible signature], and [Select during send].
DocuWorks Signature
Select the setting for DocuWorks Signature from [Do not add signature], [Always add
signature], and [Select during send].
XPS Signature
Select the setting for XPS Signature from [Do not add signature], [Always add invisible
signature], and [Select during send].

IPSec Settings

Configure the settings of IPSec.
Note
5
IKE Authentication Method
Select [Authenticate by Preshared Key] or [Authenticate by Digital Signature].
Preshared Key
Enter a preshared key. This setting is effective when [IKE Authentication Method] is set to
[Authenticate by Preshared Key].
Device Certificate
Select a certificate. This setting is effective when [IKE Authentication Method] is set to
[Authenticate by Digital Signature].
IPSec Communication
Select whether or not to enable IPSec communication.
IKE SA Life Time
Specify a lifetime in the range of 5 to 28800 minutes in 1 minute increments.
Note
IPSec SA Life Time
Specify a lifetime in the range of 300 to 172800 seconds in 1 second increments.
Note
DH Group
Select [G1] or [G2].
PFS Settings
Select [Disabled] or [Enabled].
Destination IPv4 Address
Enter the destination address or the range of the destination addresses in IPv4 format.
Note
Destination IPv6 Address
Specify the destination address or the range of the destination addresses in IPv6 format.
Note
172
• For [IKE Authentication Method], [Preshared Key], [DH Group], and [PFS Settings], consult
the network administrator.
• The value must be greater than the value set in [IPSec SA Life Time].
• The value must be smaller than the value set in [IKE SA Life Time].
• When entering an IP address, enter the address in the format "xxx.xxx.xxx.xxx", where "xxx"
is a numeric value in the range of 0 to 255.
• When entering an IP address, enter the address in the format
"xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx", where "xxxx" is a hexadecimal value.