Using The Telephone; Placing A Call - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

Using the Telephone

This section describes how to use an external telephone connected to the machine with
the fax feature.

Placing a Call

The following describes how to place a call using the external telephone.
To place a call, there are the following two methods.
Dialing with the receiver lifted (off-hook dialing)
Dialing with the receiver resting in the cradle (on-hook dialing)
Off-hook Dialing
The following describes how to place a call with the receiver off-hook.
1
Pick up the receiver of the external
telephone.
Note • While the machine is in the Energy Saver
2
Specify the call destination.
The call destination can be specified using the numeric keypad, address numbers,
or one-touch buttons. The address book cannot be used.
The call destination can be specified also
with the keyboard displayed on the screen.
Selecting [More Characters] on the screen
displays symbols.
Note • To cut the line, select [Exit (Line Cut)].
• If your telephone line is set to touch-tone,
• If you want to send tones (or to use the
• Some touch-tone services may not be
3
When the call is connected, start speaking.
4
When the call is finished, place the receiver back in the cradle.
Important • Make sure that the receiver is placed properly in the cradle. Otherwise, the line will remain
5
Select [Close].
mode, you cannot place a call using the
external telephone. To place a call, press
the <Energy Saver> button to switch out
of the Energy Saver mode.
[Tone (:)] does not appear.
touch-tone services) while using a pulse
line, select [Tone (:)].
available even if you set your telephone to send tones.
"busy".

Using the Telephone

15
543