Step 3 Configuration On The Computer - Fuji Xerox ApeosPort-III C2201 Administrator's Manual

7 Printer Environment Settings
4
Configure the following items as necessary.
Print Mode
Configure the print language on the machine to match the received data.
PJL
Enable when receiving a job using PJL commands.
The PJL commands are independent of any print languages. A print language used
in the next data can be set independently of the current print language.
Auto Eject Time
Configure the time that the data so far received by the machine will automatically be
printed since data is no longer sent to the printer.
Adobe Communication Protocol
Configure the protocol defining the communication method between PostScript
printers and a host.
Bi-directional Communication
Configure the parallel port for either half duplex transmission or full duplex
transmission.
Input Prime
When a input prime signal is received, reset processing takes place. This option is
available when [ESC/P] and [HPGL Mode] is specified for [Print Mode].
Note
7
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
Select [Close].
7
Select [Reboot Now].
8
After the machine is restarted, print out a configuration report to confirm that the
parallel port is enabled.
For information on how to print a configuration report, refer to "Print Reports" (P.83).
9
Turn off the computer.
10
Connect a parallel interface cable to the parallel interface on the computer.
11
Restart the computer.

Step 3 Configuration on the Computer

The following describes the configuration procedure for the computer.
In order to print from the machine, the computer needs to have a print driver installed.
For information on the supported OS, refer to "Supported Operating Systems" (P.260).
For information on the driver installation procedure, refer to the manual contained in the CD-ROM of
the Driver CD Kit.
262
• Adobe Communication Protocol can be configured when the PostScript 3 Kit (optional) is
installed.
• Do not change the default settings for normal use. Some items may be required to be
changed depending on the operating system on the computer.